Revisiting the ring hoop test in additively manufactured metal tubes

Pragana J.P.M.; Bragança I.M.F.; Silva C.M.A.; Martins P.A.F.; Silva, C.M.A.

Key information

Authors:

Pragana J.P.M. (João Pedro da Fonseca Matos Pragana); Bragança I.M.F. (Ivo Manuel Ferreira de Bragança); Silva C.M.A.; Martins P.A.F. (Paulo António Firme Martins); Silva, C.M.A. (Carlos Manuel Alves da Silva)

Published in

10/01/2022

Abstract

This paper is focussed on the mechanical and formability characterisation of wire-arc additive manufactured (WAAM) AISI 316-L stainless-steel tubes. The methodology to be presented involved carrying out tension and ring hoop tension tests on specimens extracted from the tube longitudinal, transverse and inclined directions. The force evolutions, acquired from the load cells, and the strain measurements, retrieved from digital image correlation and from thickness measurements along the cracks, allowed obtaining the stress-strain curves, the strain paths and the onset of failure by fracture for the three different tube directions. Special attention was paid to the ring hoop test, which was revisited to determine the appropriateness of using ring specimens with one or two dumbbell geometries. The originality of using the ring hoop tension test in WAAM tubes with strong anisotropic behaviour allowed obtaining strain loading paths that range from plane strain to pure shear deformation conditions. Resort to commercial AISI 316-L stainless-steel tubes during the presentation is included for reference purposes.