Master's Thesis

Study of Polymer-Metal Adhesion Mechanisms in Fused Filament Fabrication Process

Guilherme Alberto da Cunha Martins — 2021

Key information

Authors:

Guilherme Alberto da Cunha Martins (Guilherme Alberto Da Cunha Martins)

Supervisors:

Carlos Miguel Santos Vicente (Carlos Miguel Santos Vicente); Marco Alexandre De Oliveira Leite (Marco Leite)

Published in

September 20, 2021

Abstract

Additive Manufacturing (AM) technologies began fabricating end-use products instead of the simple parts and prototypes primary produced with it. The development of more sustainable products include the use of multi-materials and, comparing with others, Polymer/Metal Hybrid (PMH) components take the upper hand in manufacture easiness and increased weight-to-strength ratio. Then, this work intends to study the adhesion mechanisms between polymer/metal parts manufactured with Fused Filament Fabrication (FFF). Single-lap joints with two different adherends: a metallic base substrate and a polymeric top substrate were manufactured and tested by optical profilometry measurements, Scanning Electron Microscopy (SEM), Energy Dispersive Spectroscopy's (EDS) analysis and mechanical tests. Optical profilometry revealed more irregularities in non-abraded and grit blasted surfaces, comparing with those abraded by P120 sandpaper, while grit blasting technique showed higher abrasion's level. For the single-lap joints' mechanical characterization, five specimens of each pair of polymer/metal were manufactured and tensile tests were performed. The shear stress-displacement curves reflect the surface roughness and fibers' influence on adhesion strength, which translates on the higher result values obtained for Nylon CF15 polymer. Despite the phenomenon of adhesion among the list of materials used in this work not being fully elucidated, an enhanced adhesion after abrading the surface of the Aluminium adherend is evident. The importance of fibers in adhesion mechanisms was also demonstrated and the successful fabrication of several PMH joints possible.

Publication details

Authors in the community:

Supervisors of this institution:

Fields of Science and Technology (FOS)

mechanical-engineering - Mechanical engineering

Publication language (ISO code)

por - Portuguese

Rights type:

Embargo lifted

Date available:

August 19, 2022

Institution name

Instituto Superior Técnico