Master's Thesis
Design and investigation of a novel gas turbine combustor
— 2024
Key information
Authors:
Supervisors:
Published in
June 26, 2024
Abstract
Este trabalho visa operar uma câmara de combustão a gás natural com ar primário e secundário sob o regime de combustão MILD. O queimador é caracterizado por um tubo central rodeado por um injetor em swirl. Testes foram feitos vareando o diâmetro do tubo central do queimador, a configuração da injeção (1 - combustível pelo swirl e ar pelo tubo central; 2 - configuração oposta), a temperatura do ar primário, a potência, o coeficiente de excesso de ar e a percentagem de ar primário. Foram medidos perfis de temperatura axiais e radiais e emissões. Um modelo numérico preliminar foi também testado contra os resultados experimentais. Testes com a configuração 2 tiveram melhores resultados, com emissões mais baixas e uma melhor distribuição da temperatura, exceto para um diâmetro do tubo central de 6 mm em que a configuração 1 apresentou emissões de CO inferiores. Testes com todo o ar injetado pelo queimador superaram os testes com ambos ar secundário e primário, exceto para emissões de NOx. O aumento da temperatura do ar primário reduziu as emissões de CO mas aumentou as de NOx e o aumento da potência não impactou os resultados obtidos. O aumento do coeficiente de excesso de ar reduziu as emissões e a temperatura. O aumento da percentagem de ar primário reduziu as emissões de CO mas a sua influência no NOx foi inconclusiva. This work aims to operate a combustion chamber fueled by natural gas and with primary and secondary air injection under the MILD combustion regime. The burner features a central tube surrounded by an annular swirl. Tests were conducted varying the burner central tube diameter and injection configuration (1 - fuel from the swirl and air from the central tube; 2 - opposite configuration), primary air temperature, thermal input, total excess air coefficient and primary air percentage. Axial and radial temperature profiles and emissions were measured. A preliminary numerical model was also tested against experimentally measured results. Tests with configuration 2 performed better overall, with lower emissions and more even temperature distribution, except for a nozzle diameter of 6 mm where the opposite configuration showed lower CO emissions. Tests without secondary air and all air injected from the burner outperformed tests with both, except in terms of NOx emissions. The increase in primary air temperature reduced CO emissions but increased NOx. Thermal input was shown to have little impact on the obtained results. The increase of reduced emissions and lowered overall temperature but had no impact on flame visibility. The increase of primary air percentage appeared to reduce CO emissions but its influence was inconclusive for NOx emissions. Overall, a flame was always visible during testing, only appearing faded in some of the tests. The numerical model predicted temperature profiles reasonably for certain conditions but very poorly for others, and the emissions predictions seemed to not capture the behaviour obtained experimentally.
Publication details
Authors in the community:
Afonso Guerra Santoalha
ist193207
Supervisors of this institution:
Pedro Jorge Martins Coelho
ist12272
Miguel Abreu de Almeida Mendes
ist148033
RENATES TID
203843975
Degree Name
Mestrado em Engenharia Mecânica
Fields of Science and Technology (FOS)
mechanical-engineering - Mechanical engineering
Keywords
- MILD Combustion
- Pollutant Emissions
- Combustion Chamber
- Natural Gas
- Experimental
- Numerical
- Combustão MILD
- Emissões
- Câmara de combustão
- Gás Natural
- Experimental
- Numérico
Publication language (ISO code)
eng - English
Rights type:
Embargo lifted
Date available:
April 28, 2025
Institution name
Instituto Superior Técnico